Details on Configuration - Project Settings
Information about the Project Settings section in the Configuration of LINEAR Building.
You are here:
Configuration 
(Tool Bar) ➤ Project Settings
Coverage of the Heat Load
If a value > 0 is entered in the Shortage and Surplus fields, the heat load check is activated. If the relation between the dimensioned heating capacity and the calculated heat load exceeds or falls below the defined range in a room, a message is output in the log.
Options
Decimal Places for U-Value Calculation: Number of decimal places to be output during U-value calculation.
Designation for “Apartment“ for Non-Residential Buildings: Designation for rooms belonging together in buildings that are not used as residential buildings, e.g. offices on one storey in industrial buildings. The designation entered here appears in the building structure, in drop-down entries of the building data for selecting building units and ventilation zones, and in the printout.
Designation for Building Section: Alternative designation of “building section”. The designation entered here appears in the building structure, in drop-down entries of the building data for selecting building units and ventilation zones, and in the printout.
Sort rooms alphabetically
Specifies the sorting of rooms in the Building Structure.
Enabled: The rooms are sorted alphabetically in the Building Structure within the parent level by their Designation.
Disabled: The rooms are sorted alphabetically in the Building Structure within the parent level by their Designation. The Designation is only considered secondary.