Save and Update Parameters in Network Components
Shows step-by-step how to save selected parameters in network components.
Before you begin
You want to save selected parameters in network components or update network component parameters so that they can be retrieved and used, for example, when passing them on to other project participants.
Requirement:
The pipe or duct network is completely detected and calculated.
Navigate to:
Applies to all disciplines.
Procedure
- In the row of the network component to be edited, click on
Configure parameters for export. The Configure Export Parameters dialog opens.
- Activate or deactivate the desired parameters for the selected network component and click OK. Note: A number of parameters are preselected by default for each component type.
- In the Labeling dialog, click on Create Parameters in Network Components to write the selected parameters to the network component and confirm the following prompt with Yes.
- If you change values or units of network component parameters, you must perform the calculation again and then exit the calculation dialog by clicking OK so that the updated values are saved in the components.
Results
The parameters were written to the network components as configured.
