Details on the “Configure Export Parameters - ...” Dialog

Information about the Configure export parameters dialog.

In the Configure Export Parameters dialog, select the shared parameters for a component type. These parameters are saved in the network components and can therefore be output and used by other project participants when the model is passed on.

Note: If you change values or units of network component parameters, you must perform the calculation again and then exit the calculation dialog by clicking OK so that the updated values are saved in the components.

You are here:

Project tab ➤ Discipline ➤ Analyse tab ➤ Labeling... ➤ Configure export parameters ➤ … (Configure parameters for Export)

Export parameter Revit

Column

Description

Activation column

Activate the parameters that are to be created as shared parameters for the respective network component.

Clicking the head line of this column activates all entries. A second click deactivates all entries. A third click restores the previous selection.

Data type

Designation of the parameter that is assigned to a network component.

Parameters

The name of the parameter that is written to the assigned network component. In this column there are always LINEAR parameters although there may be different assignments.

Line upward/downward

Moves the selected row in the parameter list either up or down. The sequence defined here is also used for the output of the parameters.