Laying Out a Room with Modules/Panels

Shows step-by-step how to lay out a room with modules or panels of a radiant heating and cooling system.

Before you begin

You want to lay out a room component (floor, ceiling, wall) of a room with modules or panels of a radiant heating and cooling system.

Requirements:

You have added the system to be layed out to the system preselection and adjusted it to the requirements of your project.

Note:

At this point, the basic procedure is shown using the example of a floor system. Modules or panels can also be laid out with ceiling or wall systems. If a ceiling or wall system is in the system preselection, you may have to add the required room component (interior or exterior wall; ceiling or roof) manually before carrying out the process.

Navigate to:

Module Overview ➤ Radiant Heating/Radiant Cooling ➤ Room Level

Applies to: Radiant Heating, Radiant Cooling

Radiant Heating Room Linear Building

Procedure

  1. Click in an empty line in the table.
    A menu opens for selecting and/or creating the areas to be laid out.
  2. Select the area to be laid out or the area that you are creating for the design

    If necessary, the area is created as a room component and the following context menu opens:

    Radiant Heating Dimensioning Context Menu Linear Building

  3. Click on Occupied Zone(s).
    The dialog Percentages of Area of Panels opens.
    Dialog Area Shares of Laying sheets in LINEAR Building
  4. Select the desired Length or Width from the corresponding drop-down lists to filter the list of available elements.
  5. Select the desired version of the component from the Module/Panel/Element drop-down list.
  6. In the input field below the drop-down list, enter how many of these modules are to be used for this room and click on Apply Module(s) >>.
  7. Define the arrangement and connection of the modules in the room.
  8. Confirm your settings by clicking OK.

Results

The selected modules are used with the settings made and the room is laid out.