Jump directly to main navigation Jump directly to content

Setting Technical Data

Shows step-by-step how to set technical data for components.

Before you begin

The Pipe and Air Duct Network Calculations contain technical data for all components, pipes and ducts, which you can adjust and which serve as the basis for the calculation.

Navigate to:

Project tabDisciplineAnalyse tab

Applies to: Heating, Potable water, Waste water, Ventilation, Cooling, Gas.

Analyse heating Linear Revit

Procedure

  1. Open the Components section.
    Components Analyse Linear Revit
  2. Click Technical data ... <.
  3. Select the component, whose technical data you want to set.

    The dialog about the technical data opens. The technical data vary depending on the selected component type.

    Technical data boiler tank Linear Revit
  4. Enter the desired settings and confirm by OK.
  5. If necessary, click another component to set its technical data.
  6. Finish the process by Esc.

Results

The technical data of the selected components are set and saved in the project.