Making General Settings
Shows step-by-step how to set general settings for the calculation.
Before you begin
You want to make sure that all parameters are set correctly before the calculation.
Note:
This task serves as a support for setting basic parameters for the calculation. Deviating from or in addition to the steps listed, further settings may be required to obtain the desired result.
Navigate to:
Applies to: Ventilation.
Procedure
- In the Component detection area, decide whether or not to accept Modeled dimensions in the network during detection (for a selection).
- In the Calculation presettings area, enter the Height above sea level for your project to determine the correct air pressure and thus the density of the medium.
- Check and correct the values for the Outdoor air if necessary.
- Under Dimensioning presettings, specify whether the dimensioning should be based on the default values for maximum velocity and/or maximum pipe friction loss defaults.
- In the section Zeta values, specify how the zeta values are to be determined.
- Disable the option Material determination for each calculation if you have a large project and want to shorten the calculation time.
Results
The basic settings for the calculation have been made and are now taken into account by the calculation.