Details on Edit Section Part
Information on the Edit section part dialog in heating and cooling pipe network calculation.
The dialog allows you to influence the calculation by adding additional values to the calculated data and/or adjusting the maximum velocities individually. Values of the calculation dialog that change due to entries in the Edit section part are displayed in bold in the calculation dialog.
You are here:
Applies to: Heating, Cooling.
Settings
Length, Height difference
The values are taken from the model. You can change the values here. Clicking 
resets the values to the constructed dimensions.
Pipe bends 90°, Pipe bends 45°
drawn: Shows the amount of constructed bends in this section part.
additional: Enter the amount of bends that are to be given out as additional material in the material list.
Constant pressure loss
Enter an additional pressure loss for this section part.
Ambient temperature
The ambient temperature is taken from the entry in the Settings dialog and can be edited for each section part. Clicking resets the value to the value from the configuration.
Maximum values (local)
R-value
If you want to assign a different maximum pipe friction pressure gradient to this section part, enter the value here. When entering 0, the maximum value from the global settings Basic conditions dialog is used.
Velocity
If you want to assign a different maximum velocity to this section part, enter the value here. When entering 0, the maximum value from the global settings Basic conditions dialog is used.
Simultaneity
Enter the simultaneity for this section part. The simultaneity is automatically assigned to the supply and return water pipes at the same time.
The simultaneity (f) is applied to the heat flow and the mass flow.
Q* = m* c (Tv-Tr)
With the peak heat flow and peak mass flow:
Q* = Q * f
m* = m * f
Reset
Resets all entries to the values calculated from the model.