Details on Ejection Process
Information on the Temporal temperature profile (hot water) dialog in the calculation dialog for potable water.
Determine for individual hot water consumers, after which time the hot water ejects after the preset testing temperature.
You are here:
Position:
Displays the name of the hot water consumer, its section part number and the component number.
Testing period
Enter the time to be observed during the hot water ejection.
Testing temperature
Enter the temperature which is to be achieved during the hot water ejection.
Diagram: Temperature profile during the ejection process
Shows the hot water temperature in relation to the pipe length. During the simulation of the hot water ejection process the diagram is animated and shows the temporal status change.
Escape
Press Esc to interrupt the simulation of the ejection process. This state of the temperature profile can be printed.
Simulate
Starts the simulation of the hot water ejection process. Afterwards, the results are displayed underneath the diagram.
Results
After clicking Simulate the ejection times for the set testing temperature, for the steady state ejection temperature and the volume exchange time are displayed.
Component data
Displays the name, the volume flow rate and the inlet temperature of the hot water at the consumer.
Print diagram
Opens the Print preview dialog where you can view the current diagram as a print preview and print it.
Reset
Resets the results.
Close
After clicking Close you can select another hot water consumer for the simulation of the hot water ejection process. Press Enter to return to the calculation dialog.