Define Pipe Sections
Shows step-by-step how to configure the data of pipe sections.
Before you begin
You would like to set the pipe section data of your scheme for a pipe network calculation
Requirements:
Navigate to:
Applies to Heating, Potable water, Waste water and Gas.

Procedure
- In the scheme, click on the pipe section you would like to edit. The Pipe run data dialog opens.
- In the Section area, specify the Length of the pipe section and the number of Additional bends.
- Optional: In the Nominal pipe diameter section, set the nominal diameters for the pipes in the pipe section.
- Use the
and
buttons to switch to the adjacent pipe sections and set their data.
The currently selected pipe section is shown dashed in the scheme. - Use the button
to switch to vertical tether feed pipes and set their data.
- Close the dialog with OK when you have set the data of all pipe sections of your scheme.
Results
The pipe section data of the scheme are set.