Details on Storey Section <

Using the Storey section < area, you can draw to-scale and labeled storey sections for creating schemes based on the storeys defined in the storey table and the storey selection in the area itself.

You are here:

Project - tab ➤ Discipline ➤ Planning type 2D Scheme Planning ➤ Create - tab ➤ Storeys and Generators ➤ Storey section <

Storey section <

Click on the button to start the Storey section < function. You can then create a storey section according to the defined settings.

List of storeys

All storeys defined in the storey table are listed in the list of storeys. By activating the storeys in the y/n column, you determine which storeys the storey section contains.

Length, show

You can specify the length of the storey section using the Length in drawing units input field or define the length by clicking in the drawing. If storeys are defined in the storey table with negative storey heights, these storeys are drawn below the insertion point.

Show

Enabled: The length of the storey section is defined in the drawing with two clicks. The first click defines the insertion point for the left or right edge of the section at the height of the unfinished floor of the lowest storey with a positive storey height. The direction in which you move the cursor determines whether the projectile section is drawn to the right or left of the insertion point. Click a second time to define the length of the section.

Disabled: The length of the storey section is defined by entering the length in character units in the Length input field. After clicking on Storey section <, you can define the insertion point for the left edge of the section at the height of the lowest storey with a positive storey height by clicking in the drawing or enter the coordinates of the insertion point.