Jump directly to main navigation Jump directly to content

Details on Component Data for Fittings

Information about the component data dialog for fittings.

A fitting may be any installed part within the network. It has two connection points, both of which are connected to another component. You can automatically draw fittings with the Fittings < command.

You are here:

Project TabDiscipline GasPlanning TypeAnalyse TabComponentsTechnical Data ...Component Selection

Technical Data Bend LINEAR Revit

Name

Shows the name of the component. You cannot modify the name.

Calculation

For fittings, you may adjust the zeta value individually. This is then used to calculate the pressure loss at this component. If you calculate according to ÖVGW G11, the zeta value for all components is determined by the program and the field is deactivated.