Details on Section Part Data
Information about the Section part data dialog of the scheme generators.
You are here:
Applies to Heating, Potable water, Waste water and Gas.
Section
Length
Sets the length of the section part selected in the scheme. The value is applied to both the supply and return pipes. The length is then displayed in the scheme above the section part. The actual length of the section part is determined from the finished scheme and also depends on the pipe routing. The lengths are not drawn, but only stored as a value in the section part or component.
Additional bends
Sets the number of additional bends of the section part. The number of additional bends is then displayed in the scheme above the section part. Additional bends are output in the parts list after the calculation has been completed.
Pipe nominal diameter
If a pipe material is assigned, you can set nominal diameters for the pipes of the section parts here.
Dimensions listed with an asterisk in the drop-down list have been disabled in the Pipe tables. If special dimensions are to be used specifically, the deactivated dimensions are also available for selection here.
Pipe type
This section is available only for waste water section parts and defines the pipe type of the section part.
Navigation buttons
, 
, 
Use the and buttons to switch horizontally between the section parts of the scheme. The active section part is shown dashed in the scheme.
With the button you can switch to the vertically running feed pipes. The active section part is shown dashed in the scheme.