Making General Settings
Shows step-by-step how to set general settings for the calculation.
Before you begin
You want to make sure that all parameters are set correctly before the calculation.
Note:
This task serves as a support for setting basic parameters for the calculation. Deviating from or in addition to the steps listed, further settings may be required to obtain the desired result.
Navigate to:
Applies to: Gas.
Procedure
- In the section Component detection, decide whether the Pipes in the scheme should be entered with a different length or height factor.
- In the section Calculation presettings, select the desired design method from the drop-down list.
- Check the Basic conditions and adjust the values if necessary.
- Specify which method is to be used for the Determination of the pressure loss.
- Disable the option Detect material with every calculation if you you are working on a large project and want to shorten the calculation time.
Results
The basic settings for the calculation have been made and are now taken into account by the calculation.