Details on Component Data for Potable Water Cooler
Information about the component dialog for the potable water cooler.
You are here:
Name
In this field you can enter an individual name for the component. If you click the icon 
, the original name will be restored and the previous entry will be overwritten.
Name Circulation system
Name for the circulation system to be entered freely. The entered name is displayed in the calculation dialog in the system selection.
Settings
Cold water temperature
The temperature of the water is taken from the Circulation settings in the calculation dialog. You can enter a deviating value. Manually entered values are displayed in bold. Click 
resets the manually entered value to the value from the settings.
Heat exchanger pressure loss
Enter the pressure loss of the heat exchanger in the potable water cooler.
when circulation flow rate
Enter the volume flow rate of the circulation pipe.
contains pump, calculate
Enabled: In the calculation, the presence of a pump is simulated for the pipe network. You can determine the capacity of the pump by activating the calculate checkbox during the calculation, or you can set the pump pressure manually. Manually entered values are displayed in bold. Clicking resets manually entered values to value calculated pump pressure. If additional pumps are found in the pipe network, an error message is displayed in the Reports.
Disabled: In the calculation, no pump is simulated for the pipe network and the installation of a separate pump is required. If no pump is installed, during calculation an error message appears in the Reports and the network cannot be calculated.