Spring direct naar de hoofdnavigatie Spring direct naar inhoud

Details on Technical Data for Drainage Elements

Information about the technical data dialog for drainage elements.

The drainage element and its parameters determine the flow rate into the drainage network.

You are here:

Project TabDisciplineAnalyse TabComponentsTechnical Data ...Component

Dialog Technical Data LINEAR Revit

Name

In this field you can enter an individual name for the component. Clicking on restores the original name and overwrites the previous entry.

Settings

In this dialog, set the discharge data for the drainage element. These settings only need to be made if you intend to use values for calculation that differ from Table 4 of EN 12056-2. Here, enter either a Connection value or a Continuous flow rate. Under Pre-adjusted dimension, enter the minimum nominal diameter of the connector pipe.

Preset Toilet

The default values for toilets can be changed in the individual technical data dialogs. If the default values for all toilets are to be changed, make the change in the Settings on the Drainage tab.