Detecting Building

Explains the concept of building detection as an interface between the LINEAR Solutions for Autodesk Revit and LINEAR Building.

The preparation and construction of your pipe or duct network takes place in Revit. The analysis and calculation of the building loads then takes place in LINEAR Building. The Building Detection function bundles all relevant data and makes it available for detection with LINEAR Building The transferred data is used to create a thermal building model in LINEAR Building that can be as detailed as desired.

In LINEAR Building, you can define whether and how certain parameters are transferred during building detection in the configuration before detection. If required, thermally relevant components from Revit can be assigned to a component previously defined in LINEAR Building from the master tables via a shared type parameter in order to be able to use the thermal properties of the user-defined component for the load determination.

On the Analyse tab, you can make the settings for building detection of the architecture on the Revit side.

For detailed information on how to isolate and prevent modeling problems in interaction of Autodesk Revit and LINEAR Building, see the Recommended procedures for building preparation section.