Configuring the Heat Transfer System Globally and at Room Level

Shows step-by-step how to set up a heat transfer system for rooms higher than 4 m, both project wide and room specific.

Before you begin

You would like to set a project wide and room specific heat transfer system for rooms higher than 4 m.

Navigate to:

Module overview ➤ Heat load ➤ Project level ➤ General heat load data

Heat transfer system Linear Building

Procedure

  1. Open the drop-down list under Heat transfer system and select a heat transfer system.

    If you do not want to make a correction for rooms over 4 m, select the entry No correction.

  2. If you would like to individually assign a heat transfer system to rooms with a height of more than 4 m, switch to the corresponding room in the building structure and to the Transmission area on the Heat load tab.
  3. In the drop-down list select under Heat transfer system for rooms higher than 4 m the heat transfer system for this room.

Results

The heat transfer system is set both, globally and in all relevant rooms.