Setting summand f1 or adjoining temperature
Shows step by step set the adjoining temperature or the summand f1 in rooms.
Before you begin
You would like to adjust the summand f1 or the adjoining temperature in selected rooms.
Note:
The corresponding fields are enabled for editing if a component is adjacent to generally heated or to unheated rooms. For adjoining temperatures, either a predefined value from the configuration or a value from a steady-state heat balance is suggested.
Navigate to:
Procedure
- Enter a value in the Summand f1 column or in the t column for the corresponding components.
- Repeat this step for all desired rooms of the building.
Results
All relevant components have been given an individual temperature correction.