Details on Perspective
Information about the Perspective command.
You are here:
The command Perspective < is allows you to set the perspective on your drawing, i.e. viewing direction, cropping, focal length, eye level and target level.
This allows you to set very effective and realistic perspectives on your plans in three-dimensional planning, for example, to make them more vivid and transparent for the building owner. Detailed problems can thus very often be described with a few pictures.
Click the Perspective < button on the left and determine the point and direction of view by specifying two points in the drawing for this purpose.
Focal length
The focal length changes the horizontal angle of view from normal (50 mm) to an extreme wide angle (10 mm). Use the button to transfer the changed setting to the drawing.
Eye level
The eye level is relative to the upper edge of the finished floor of the currently set storey. For for example, if you are on the 1st storey at 3 m, and you set the eye level to 1700 mm, the total eye level is 4700 mm.
Target height
The difference between eye level and target height defines the viewing direction in the vertical plane. The target height is also relative to the upper edge of the finished floor of the currently shown drawing.
The button transfers the set target height to the drawing.
Edit <
The button is used to transfer the respective set value to the drawing.