Details on Draw rigid pipe
Information on the Draw rigid pipe command under Piping.
The availability of the described commands for drawing in, connecting and configuring pipes may vary depending on the trade and planning type.
You are here:
Draw rigid pipe <
Use the Draw rigid pipe command to draw pipes from the starting position through corner points to the end point in one step. Start, corner and end points can be freely determined. In addition, you can use the object snap modes to draw, so you can connect a pipe to an endpoint, for example.
This command depends on the drawing type setting. In a 2D drawing, the pipe is created in the current construction plane. In a 3D drawing, you can also design a three dimensional pipe.