Editing Properties of Multiple Circuit Zones

Shows step-by-step how to change the properties of multiple circuit concurrently.

Before you begin

You would like to modify the properties of multiple circuit zones in a room concurrently.

In the example, the general procedure is shown using the HR VM laying pattern. You can also carry out the procedure with the System, Pipe run/Manifold (Pipe run/manifold-VA), laying spacing (VA cm) and differential temperature (Diff. temp. K).

Requirement:

In the room in question, you have assigned a panel heating/cooling system, which consists of several circuit zones, to a room component (floor, wall, ceiling).

Navigate to:

Module overview ➤ Panel heating/Panel cooling ➤ Building Structure ➤ Room level ➤ Panel heating/Panel cooling

Applies to: Panel heating, Panel cooling

Procedure

  1. Click in a line of the property to be modified, in our example OR LP.

  2. Hold down the left mouse button to mark the lines in the circuit zone to be modified.

  3. Press F8.

    The context menu or the dialog for the property to be modified opens.

  4. Modify the property to the desired setting.

Results

You have made the Modification in the marked lines.