Direkt zur Hauptnavigation springen Direkt zum Inhalt springen

Details on Component Data for the Partial Network End

Information about the dialog for component data for the partial network end.

You are here:

Project tabDisciplineAnalyse tabComponentsTechnical data ...Component

Technical data partial network end Linear Revit

Name

Specifies the name of the component. You can modify the name. Clicking restores the default setting.

Thermal capacity and Mass flow rate

If the partial network end is used as a consumer device, you may specify either the Thermal capacity or the Mass flow rate. The other value will be re-calculated on the basis of the supply and return temperatures. Activate the respective checkbox and enter the value.

If a partial network end is connected to a partial network start, these options will be grayed out and will thus not be available. The relevant values will be taken over from the partial network start.

Zeta value, Pressure loss

If the partial network end is used as a consumer device, you may specify either the Zeta value or the Pressure loss. To do so, activate either Zeta value or pressure loss and enter the value.

If a partial network end is connected to a partial network start, these options will be grayed out and will thus not be available. The relevant values will be taken over from the partial network start.

Water volume

If the partial network end is used as a consumer device, you may additionally specify the water volume of the component represented by the pipe run outlet.

Connection

Using the Assign < function you may connect the partial network end with a partial network start of another partial network. Please note that you may assign only one pipe run inlet to a pipe run outlet.

If you connect the partial network end to a partial network start, the dialog is reduced to the section Connection. Three additional buttons will then be displayed. Click Unfix to remove the connection and the dialog will be reset to the original view with all component data. Use button to to show the connected partial network start network in the model. The program zooms in on the part and also marks the position with an arrow. After clicking the button , the program displays both partial network start and partial network end of the connection and marks the connection with a broken line. The partial network start is additionally marked with an arrow in this view.

Connecting partial networks via the pipe run outlet is appropriate when intending to calculate a previously existing network together with a new pipe network. For that purpose, draw the network starting with the partial network start and assign the partial network start to the partial network end or enter the value of the existing network directly at the partial network end.