Direkt zur Hauptnavigation springen Direkt zum Inhalt springen

Details on Connection at this Component

Information about the Connections at this component dialog in the pipe network calculations heating, cooling and potable water.

Some components have multiple connections which can be defined together or individually. The corresponding fittings are then listed in the parts list.

You are here:

Project tabDisciplineAnalyse tabComponentsConnections ...Select component

Applies to: Heating, Cooling, Potable water.

Dialog “connections on this component” of the LINEAR Solutions for Autodesk Revit

All connections at the component are the same.

Enabled: Only the tab All is displayed, where you specify the connection type for all connections of the component.

Disabled: A separate tab is displayed for each connection of the component. This allows you to define the connection type for each connection separately.

Tabs: All , Connection 1, Connection 2

On the tab All you define the connection type for all connections of the component.

On the tabs Connection 1, Connection 2 etc. you define the connection types for the individual connections of the component separately. For better orientation, the connected pipe of the currently selected connection is highlighted in the model.

Manufacturer

Drop-down list for selecting the manufacturer.

Calculated pipe dimension:

Shows the nominal diameter of the connected pipe determined by the calculation.

Type of connection on the component:

Drop-down list for selecting the type of connection.

List of connection dimensions

Displays the available nominal diameters for the selected connection type and enables their selection.