Direkt zur Hauptnavigation springen Direkt zum Inhalt springen

Select Calculation Base

Shows step-by-step how to select a calculation base for your heat load.

Before you begin

You have detected the building and would like to set the correct calculation base before the calculation.

Navigate to:

Module overviewHeat loadProject levelGeneral heat load data

Heat load data Linear Building

Procedure

  1. Open the drop-down list Basis of calculation.

    The list of available standards depends on the selected region.

  2. Select the desired standard.
  3. If you change the calculation base, you may be notified that manually entered values will be overwritten. If this is what you want, click Yes.

Results

The relevant standard is selected and will be used as the basis for calculation immediately.