Using T-piece Connection
Shows step by step how to connect two pipes or a component and a pipe using a T-piece.
Before you begin
Two pipes or a component and a pipe should be automatically connected by a T-piece. The function is well suited for connecting sanitary components to waste water pipes.
Requirements:
-
One of the two pipes or the component has an open end.
-
The distance between the open end and the pipe is large enough to be able to construct a connection.
Navigate to:
Applies to: heating, potable water, waste water, ventilation, cooling, gas, fire protection.
![](https://knowledge.linear.eu/LS/V23/EN/RV/en/topics/../figures/comm_tabKonAW_RV.png)
Initial situation:
![](https://knowledge.linear.eu/LS/V23/EN/RV/en/topics/../../common/figures/neZe_tStueckAnbinden6_RV.png)
Procedure
- Click T-piece connection.
- Select an open end and a pipe or duct.
- Select the angle for the T-piece and confirm with Apply.
Different variants for the situation are shown.
- Select the required variant using
and confirm with Apply.
Results
The component is connected to the pipe.
![](https://knowledge.linear.eu/LS/V23/EN/RV/en/topics/../../common/figures/neZe_tStueckAnbinden7_RV.png)