Direkt zur Hauptnavigation springen Direkt zum Inhalt springen

Details on Crossover <

Information on the section Crossover.

This command creates a bridge symbol symmetrical to an intersection point.

You are here:

Desktop2D Floor plan/3D DrawingCreate tabCrossover <

When two pipes intersect, the line at the lowest point is displayed interrupted at the intersecting point. A block is inserted on the Fittings layer so that the pipe connection remains traceable for a subsequent calculation with the LINEAR Analyse programs. The command only works on rigid pipes. Flexible pipes cannot be intersected.

Width

Defines the width of bridge. Use to pick values from the drawing.