Details on Edit Section Parts
Information about the Edit section part dialog in the Potable Water Pipe Network Calculation.
The dialog allows you to influence the calculation by adding additional values to the calculated data and/or adjusting the maximum velocities individually. Values of the calculation dialog that change due to entries in the Edit section part are displayed in bold in the calculation dialog.
You are here:
Settings
Length
The value is taken from the drawing. But you can change the value here. Clicking 
resets the values to the drawn dimensions.
Pipe bends 90°, Pipe bends 45°
drawn: Shows the amount of constructed bends in this section part.
additional: Enter the amount of bends that are to be given out as additional material in the material list.
Appliances pressure loss
Enter an additional pressure loss for appliances in this section part.
Calculation
Maximum velocity
If you want to assign a different maximum velocity to this section part, enter the value here. If the entry is 0, the maximum value from the global Settings is used.
Dimensioning according to available R-value
Enabled: The section part is dimensioned according to maximum velocity and available R-value.
Disabled: The section part is only dimensioned according to maximum velocity.
Sound limit
This drop-down list is available if you selected the Russian potable water standard SP 30.13330.2020 as the method in the Configuration dialog. From the list, you can select the sound limit in dB(A) that should apply to the selected section.
Reset
Resets all entries to the values calculated from the drawing.