Configure Ventilation at Project Level

Shows step-by-step how to set the ventilation system at the project level.

Before you begin

You would like to configure the ventilation system for your project.

Navigate to:

Module overview ➤ Heat load ➤ Project level ➤ General heat load data ➤ Ventilation

Procedure

  1. Select a ventilation system from the drop-down list.
  2. Enter the efficiency of the heat recovery system η value (HR).
  3. If the Specific air permeability (10 Pa) known (ISSO 53) is known, activate the option and enter the value.
  4. If you would like to get an error message in the ventilation zone in case of an unbalanced air volume balance, activate the option Check air volume balance.

Results

The ventilation at project level is configured.