Re-sorting Manifold Connections
Shows step by step how you can re-sort manifold connections.
Before you begin
You would like to change the order of the feed pipes at the manifold before drawing in the circles.
In this example, the first two manifold connections are assigned to the two circuits of the living room. In order to move one or more lines around a single manifold connection or move them to the end of the table, use the other buttons of the Connection sequence section.
Requirement:
Your project includes several circuits.
Navigate to:
Applies to: Radiators, cooling convectors, panel heating, panel cooling.
Procedure
- Mark the desired lines with the left mouse button held down.
- Click .
Results
Both circuits are assigned to the first two connections.